Hi Clank,
Nope, the ram is not spec to 6-6-6-18,
but I run them, according to the guide, with loose timings at 6-6-6-15
These are the specs straight outta Mushkins home,
Frequency: 1066MHz
Latency: 5-5-4-12
Parity: Unbuffered
Voltage: 2.2-2.35V
Pins: 240
Density > > > Really fat (=Module: 128Mx64 Chip: 64x8)
About the cooling,
I dont have nouf room even for a 80mm fan, my chassi is to tight for even a toothpick between the thermalright ultra extreme and my drives, and between those are of course the ram slots...
When I get my digital camera back (borrowed it 2 my mate) I can post a pic for your approval =)
With this obstacle I had to choose between my own (ugly) home made solution,
an 120mm with a wind tunnel (glued together as a tubing).
But decided to go with a finished solution,
had to choose amongst other ram coolers between these
This looks pretty, but I cant help to feel it doesnt look particularly efficient...
This bugger is real shiny and pretty (me like chrome) BUT, is it just me or is those holes like 10 percent of the surface? Doesnt it look like it has a strangle hold on those fans suffocating that airflow?
Finally went with this, known brand and not looking to wide for fitting in my chassi, looking plenty free airflow...
Never found any good test for these thingies though, so I just choose what looked most efficient...
Never had me one of them Yate Loony fans, not very common brand here in sweden. Read boutem though, and recently found them in a danish webstore. Pherhaps ill try them out.
Now I have two emb papst 120 fans (limited ed) on my drives (those IN the chassi) another of the same in the back helping pulling the air outta my Thermalright with double Scythe (28db type) push'n pull config.
Also placed it that way so my Seasonics 120mm fan helps pull air from the top.
I have another fan mounted on the "door", a 250mm pushing in fresh air from the side.
(Slightly modified it so I can close it despite the Thermalright.)
I hope my new ram cooling will pop up tomorrow.
Thank you for your advice Clank, I am downloading memtest 1,7 as I write.
I backed up my oc to 333 x 9,
what timings and divider would u run these mem caps with on my bios settings Clank?
(From the short test I mentioned earlier I got the notion that the spec timings would charge me on that higher end of the voltage bill, thats why I got obsessed with the ram cooling being trustworthy.)
/Silverbullit