Ok, so i had another attemp at the cable management! I think I have have improved it this time. I managedto get the main power connection to the motherboard, but i have to twist it pretty hard to get it "point" to the socket then push it in.
Another shot at the side window panel from the outside:
After that, i tried to get 4 pin molex connector up the top, so i unscrewed the motherboard and routed it underneath but was short so i couldn't do that.
I can't turn the psu upside down either because it wont fit in. I even tried to take out the metal rack that i screwed the psu into it to hold it but when i turned it upside down, the screw holes wont align. The pic will probably explain it better than i do
, you can see that there is a thing at the bottom of the case stop me move the psu down further.
Ah, i know what you mean about the side panel and the window now! Here is my answer:
so no, they dont use screws or rivet or split wire lol, they are like thin metal clip then bend it to hold into the window.
Talking about origami
, i though i may show you this hehe, it's been sitting on my bookshelf collecting dusk for years!
Not sure if it's my psu but the fan at the rear sort of like stop then start then spin fast then stop again...