 |
||||||||||||||||||||||||||||
 |
 |
|||||||||||||||||||||||||||
|
||||||||||||||||||||||||||||
|
Welcome to the HEXUS.community discussion forums forums. You are currently viewing our boards as a guest which gives you limited access to view most discussions and other features. By joining our free community you will have access to post topics, respond to polls and access many other special features. Registration is fast, simple and absolutely free so please, join our community today! |
|
|||||||
 |
|
|
LinkBack | Thread Tools |
20-01-2006, 02:57 AM
|
#1 (permalink) |
|
Member
Join Date: Feb 2005
Posts: 76
Thanks: 0
Thanked 0 Times in 0 Posts
|
Theater 550 Pro + splitter/signal booster signal problems
I have a signal booster from Radio Shack and 2 TVs going off it and one connection to the Theater 550.
Whenever one of the TVs is turned on the signal to my Theater 550 dies. MCE and MMC will will give a no signal error message and PowerCinema shows a garbled display. Everything is fine when I connect it to a regular TV set though. This is a regular NTSC cable signal. I've found that if I run the cable through a VCR then to the 550 everything is fine. Only problem is the signal quality gets really poor after running it through the VCR which kind of defeats the purpose of the signal booster. Is there anything else I can use to clean up the signal some how? |
|
|
|
| Breadcrumb | ||||||
|
||||||
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SN45G and Ati 9700 Pro problems | joe | Small form factor & portables | 15 | 02-02-2004 03:00 AM |
