Corsair 600T Top fans

[0100001]

Hi does anyone know whether you can fit 140mm fans in the top in place of the 200mm pre-fitted one? Are the mounting holes 120 mm only and if so can you fit 140mm fans with 120 mm mount holes? Thanks in advance

[Ttaskmaster]

Hi does anyone know whether you can fit 140mm fans in the top in place of the 200mm pre-fitted one?

No, you cannot.
Not easily, anyway.
You might be able to jury-rig something with spacers, but it does not natively support 140mm. The space is designed for a 240mm rad and/or twin 120mm fans.

Are the mounting holes 120 mm only

Yes, especially the one at the back.

can you fit 140mm fans with 120 mm mount holes?

Not without modifiers, or careful rigging up with the holes in the top grille.

Thanks in advance

You're welcome!

[0100001]

Thats great. Thanks again

[PaulM1]

Not without modifiers, or careful rigging up with the holes in the top grille.

or a friend with a modicum of DIY skill equipped with a drill and bit .

that where the fun begins.

[Ttaskmaster]

or a friend with a modicum of DIY skill equipped with a drill and bit .
that where the fun begins.

I assumed the OP wasn't looking to start mucking about with case mods...

If the OP *does* want to muck about, the OP could quite reasonably get a pair of 200mm fans in the top... Couple of threads on another forum showing the build on that, wherein I believe the poster has FOUR Bitfenix Spectre Pro 200mm fans in Push-Pull exhausting through a top 400mm Phobya Xtreme... and the same 4-fan setup as a front intake!!!

All this in the same Corsair 600T!