I am restoring an Oliver model 9 typewriter dating from about 1917
When I got it from ebay it took a bad knock in posting and the carriage rail was shared off the two bolts holding it on. I was able to remove what was left and then the fun looking for the right screw started.
Going by the chart on Wiki for UNF I need a Number 8 UNF but the best I can find is a Number 10. I have used metric and imperial all my life and to be honest unsure about Unified Thread Standard.
Also taking measurements I am not sure the above is what I need, width of thread. 4.36mm / 0.172" but this does not really match any charts I have found.
Any help would be greatly appreciated.