![]() | ![]() |
|
Welcome to the HEXUS.community discussion forums forums. You are currently viewing our boards as a guest which gives you limited access to view most discussions and other features. By joining our free community you will have access to post topics, respond to polls and access many other special features. Registration is fast, simple and absolutely free so please, join our community today! |
|
|||||||
| The Pitstop Need technical or mechanical advise for your motor? This is the place to be. |
![]() |
|
|
LinkBack | Thread Tools |
|
|
#1 (permalink) |
|
Registered User
Join Date: Oct 2006
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
|
Help!...Peugeot306 XSi engine idle/cut out problem!!!
Hi all, could really use some guidance on this,
I have a 1998 peugeot 306 2.0 XSI and recently i have been problems with its idling. The needle on the rev' counter oscillates between 300 - 1500 rpm, and more often than not the engine just cuts out. The problem occurs when the clutch is pressed down. This problem is intermittent, it will happen on only a few days in a month, but when it does happen it will continue throughout the entire day! I have read similar problems on this forum, along with their solutions, but no one has really come back and said that the problem has been fixed Any help or advice is greatly appreciated Thanks in advance guys! |
|
|
|
|
|
#2 (permalink) |
|
My name is James
Join Date: Aug 2003
Location: Wilts
Posts: 1,346
Thanks: 14
Thanked 10 Times in 10 Posts
|
if it's when the engine has been running, specifically when slowing down/stopping, it could be related to the egr valve (exhaust gas recirculation) which is linked to idle speed...
|
|
|
|
|
|
|
#3 (permalink) |
|
Registered User
Join Date: Oct 2007
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: Help!...Peugeot306 XSi engine idle/cut out problem!!!
i also have 306 auto but it suddenly slows down and cuts out a then takes about 5 mins to start again it has been to garage for service before problem started and have had it back since they say no fault found
|
|
|
|
|
|
#5 (permalink) |
|
Registered User
Join Date: Nov 2007
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: Help!...Peugeot306 XSi engine idle/cut out problem!!!
hi,
I had this same prob on my P97 306 XSi 2.0 8v - tried everything - stepper motor, lambda sensor, nothing worked.... in the end disconnected battery, disconnected ECU waited for 5 mins for it to reset and never had the prob again! hope this helps! |
|
|
|
|
|
#6 (permalink) |
|
Senior Member
Join Date: May 2004
Location: Oxford
Posts: 467
Thanks: 1
Thanked 4 Times in 4 Posts
|
Re: Help!...Peugeot306 XSi engine idle/cut out problem!!!
could be the throttle body ( in between the air filter and carb )
u can clean with electrical contact cleaner ( not always but at £5 a can its cheaper than throttle body |
|
|
|
|
|
|
#7 (permalink) |
|
Registered User
Join Date: Jun 2008
Posts: 2
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: Help!...Peugeot306 XSi engine idle/cut out problem!!!
Originally Posted by b68ap
i had a similar problem with na 97 xn 1.4 mine used to cut out randomly some days it would be alright some days it would just die on me when revving it and idleing i had to coast it to junctions left foot brake and rev it hard to keep it from dyieng
i had ht leads allsorts remapping, diagnostic checks, ecu runs but the problem was the coil pack it need replacing so i went off and did it and it was perfect ever since |
|
|
|
![]() |
| Breadcrumb | ||||||
|
||||||
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| XFX 6800GT Problem | nvisage | SCAN.care@HEXUS ![]() |
45 | 07-08-2006 12:28 AM |
| SN25P PSU or PCI-E problem!? | SilverFern | Small form factor & portables | 1 | 19-01-2006 09:51 AM |
| Right car peeps, I know a girl with a garage problem... | MD | HEXUS.automotive - Cars & Bikes | 23 | 08-08-2005 11:05 AM |
| DVI problem, pc won't start! help needed. | snowwolf | Graphics cards and Monitors | 0 | 27-01-2004 05:01 PM |