KN9 Ultra Ram volts problem
Hi,
just installed and setup the KN9 Ultra with an X2 5200+ and 2 Gb of GeiL CAS 4 Ultra low latency PC 6400 ram.
It's supposed to run at 2.1 volts but the bios sets it to 1.8 volt and the pc crashes/reboots.
If I set it to 2.10(2.1v?)then the pc boots and runs but Abit EQ shows that the volts are too high.
It shows DDR2 Value =2.10v, limit = (in red says it is )1.62v-1.98v Warning
DDR2 VTT =1.05V, and in red says 0.81v-0.99v Warning
Why is this and what do I need to change?
Also in the bios is a setting for DDR2 Ref voltage and it is set to 0.0
Bios is latest(20).
One other thing is when set to auto the bios sets the ram to 5-5-5-18 2T instead of the 4-4-4-12 1T it is supposed to run at.
