IP35 - Pro Temps

[KiMi-Tech]

Hi, im a little worried about the pwm temps on my ip35-pro board. they seem to peak around 75-80 degrees oC under heavy/full load (gaming, rendering, FEA analysis etc) are these temps ok? I read on another forum that replacing the push-pins holding down the heatsink with nuts n bolts can give it better contact and reduce the temps, if i did this would it void my warranty?

My system is a q6600 g0 running at 3.384Ghz (375fsb) @ 1.33v and my ram is at 2.2v i think i may have increased the mch voltage by a notch aswell (cant remember).

Thanks for any help, Kieran

[BUFF]

75-80C should be fine.
If you are worried then think about fixing a fan blowing over the PWM heatsink.