IP35 Dark Raider - HDD and Power LED Wires
Hi
I've set up my Dark Raider in a Coolermaster Cosmos.
The power and reset buttons are working fine, but the LEDs are not.
The small arrow on the wires which plug into the board - does that indicate positive?
For the power LED, the Abit manual says connect it to these two pins but theres a blank in between them, but the wire from the case is only a 'two' - so it will only fit on one pin at a time?
Thanks
Re: IP35 Dark Raider - HDD and Power LED Wires
the triangle is normally +.
you could try it on the SLED pins instead or get either single or triple connectors blocks & swap the cables over onto those?
e.g. Maplin > Colour Single Pin Interconnect Cables
Re: IP35 Dark Raider - HDD and Power LED Wires
Thanks Buff ! :bowdown:
The HDD led was the wrong way around :stupid:, I had tried it the other way and I thought it didnt work, but must have just been because there was no HD activity.
For the 3 pin power pins, I hacked the wire.