IP35 Dark Raider - HDD and Power LED Wires

[Logitech]

Hi

I've set up my Dark Raider in a Coolermaster Cosmos.

The power and reset buttons are working fine, but the LEDs are not.

The small arrow on the wires which plug into the board - does that indicate positive?

For the power LED, the Abit manual says connect it to these two pins but theres a blank in between them, but the wire from the case is only a 'two' - so it will only fit on one pin at a time?

Thanks

[BUFF]

the triangle is normally +.
you could try it on the SLED pins instead or get either single or triple connectors blocks & swap the cables over onto those?
e.g. Maplin > Colour Single Pin Interconnect Cables

[Logitech]

Thanks Buff !

The HDD led was the wrong way around , I had tried it the other way and I thought it didnt work, but must have just been because there was no HD activity.

For the 3 pin power pins, I hacked the wire.