Results 1 to 15 of 15

Thread: turbo advice

  1. #1
    My name is James J4MES's Avatar
    Join Date
    Aug 2003
    Location
    Wilts
    Posts
    1,455
    Thanks
    39
    Thanked
    24 times in 21 posts

    turbo advice

    drove an mx5 turbo today... didn't turn me on loads, and i need to know if it's fixable... it's got a small low pressure HKS turbo, and no intercooler, with a digital injector/fuel thingy (little black box) on the steering column...

    it runs poorly, hunting around at idle, doen't run smooth at constant revs, and didn't really pull a whole lot better than my old NA 5...

    so, would an intercooler fix the power problem? and would the timing or fuel/air affect the running (the salesman said it wasn't running smoothly because it's an aftermarket mod, which needs more tuning - he also said because it's a small turbo the power kicks in earlier and is less pronounced)

    any ideas?
    http://www.helpforheroes.org.uk

  2. #2
    Senior Member Russ's Avatar
    Join Date
    Jul 2003
    Posts
    5,201
    Thanks
    11
    Thanked
    69 times in 44 posts
    poor idling can be lots of things, not enough air, dirty plugs, etc.

    as for power, the intercooler just makes you air colder allowing you to cram more in at the same time so u'd see the gain in performance, but turning the boost up, with a Boost controller will get you power, fast.

  3. #3
    HEXUS.timelord. Zak33's Avatar
    Join Date
    Jul 2003
    Location
    I'm a Jessie
    Posts
    35,176
    Thanks
    3,121
    Thanked
    3,173 times in 1,922 posts
    • Zak33's system
      • Storage:
      • Kingston HyperX SSD, Hitachi 1Tb
      • Graphics card(s):
      • Nvidia 1050
      • PSU:
      • Coolermaster 800w
      • Case:
      • Silverstone Fortress FT01
      • Operating System:
      • Win10
      • Internet:
      • Zen FTC uber speedy
    souns more serious than basic stuff mate.....only thing CHEAP in my mind is a gasket....inlet manifold or turbo gasket?

    Otherwise......a lpt (low oressure turbo0 SHOULD make you laugh all day long and if it doesnt...its broken

    Quote Originally Posted by Advice Trinity by Knoxville
    "The second you aren't paying attention to the tool you're using, it will take your fingers from you. It does not know sympathy." |
    "If you don't gaffer it, it will gaffer you" | "Belt and braces"

  4. #4
    Administrator Moby-Dick's Avatar
    Join Date
    Jul 2003
    Location
    There's no place like ::1 (IPv6 version)
    Posts
    10,665
    Thanks
    53
    Thanked
    385 times in 314 posts
    an intercooler allows you to sustain higher boost levels throughout the rev range afaik.

    I'd suggest you have the AFC tuned properly - they are hard to set up correctly without skill and a rolling road
    my Virtualisation Blog http://jfvi.co.uk Virtualisation Podcast http://vsoup.net

  5. #5
    Senior Member
    Join Date
    Jul 2003
    Posts
    12,116
    Thanks
    906
    Thanked
    583 times in 408 posts
    Intercooler cools the air going into the engine basically making it denser, the denser the air the more fuel u can whack in meaning bigger bang more power...

    Wait till Lowe gets here he's better with wordin

  6. #6
    Va Va Voom Lowe's Avatar
    Join Date
    Jul 2003
    Location
    Newcastle Under Lyme
    Posts
    6,748
    Thanks
    323
    Thanked
    359 times in 267 posts
    • Lowe's system
      • Motherboard:
      • Gigabyte Z97MX Gaming 5
      • CPU:
      • Intel i5 4690K
      • Memory:
      • 16GB Crucial Ballistix Tactical
      • Storage:
      • Crucial M550 256GB and 1TB spindle drive
      • Graphics card(s):
      • Palit Geforce GTX1080 Jetstream
      • PSU:
      • EVGA 600w
      • Case:
      • Coolermaster Silencio 352 m-ATX
      • Operating System:
      • Win 7/Mac OSX
      • Monitor(s):
      • 27" 1080p AOC, Oculus Rift CV1
      • Internet:
      • 200mb Virgin VIVID
    Been away for the weekend without net access so I'm a little behind here guys - sorry

    Anyway, an intercooler is there to reduce the charge (compressed air) temperature. Lower charge temps are good for 2 reasons:

    1) Denser air as Trig says
    2) Far less likely to pre detonate the mixture of fuel/air

    Even on a LPT I'm suprised they didn't include an intercooler, since turbos kick out some serious heat even when doing next to nothing!

    The dodgy running is probably down to the fact that the ECU hasn't been tweaked properly so it's not fuelling correctly. Bad idling can be due to a lot of stuff really.

    It probably needs a good rolling road session to iron out the problems, but to be honest I wouldn't pay money for it until it's running properly!

  7. #7
    My name is James J4MES's Avatar
    Join Date
    Aug 2003
    Location
    Wilts
    Posts
    1,455
    Thanks
    39
    Thanked
    24 times in 21 posts
    sorry, i know what one does, just wondered how much difference having one makes, especially here in the UK where air temp isn't always that high...

    i've been quoted £800+ fitting for adding an intercooler, so i don't think i'll bother...
    http://www.helpforheroes.org.uk

  8. #8
    Senior Member
    Join Date
    Jul 2003
    Posts
    12,116
    Thanks
    906
    Thanked
    583 times in 408 posts
    Doesnt matter if the air temps not high tbh, your turbo gets damned hot and that'll warm up anything that gets near it....

    £800 is rather a rip off for an IC tbh, I'd say check around...

  9. #9
    Administrator Moby-Dick's Avatar
    Join Date
    Jul 2003
    Location
    There's no place like ::1 (IPv6 version)
    Posts
    10,665
    Thanks
    53
    Thanked
    385 times in 314 posts
    £800 is a Lot for an IC.

    I wonder if you coudl git the WMIC from a 200 in there - you'd have a great supply of them from 200sx owners who fit FMIC ( mine is from a Saab )

    If you think you can bodge it , you are welcome to my old WMIC.

    Get yourself some samco hoses and bob's your uncle
    my Virtualisation Blog http://jfvi.co.uk Virtualisation Podcast http://vsoup.net

  10. #10
    My name is James J4MES's Avatar
    Join Date
    Aug 2003
    Location
    Wilts
    Posts
    1,455
    Thanks
    39
    Thanked
    24 times in 21 posts
    i'm up for that! a/s/l?
    http://www.helpforheroes.org.uk

  11. #11
    Administrator Moby-Dick's Avatar
    Join Date
    Jul 2003
    Location
    There's no place like ::1 (IPv6 version)
    Posts
    10,665
    Thanks
    53
    Thanked
    385 times in 314 posts
    I'm in Milton Keynes
    my Virtualisation Blog http://jfvi.co.uk Virtualisation Podcast http://vsoup.net

  12. #12
    My name is James J4MES's Avatar
    Join Date
    Aug 2003
    Location
    Wilts
    Posts
    1,455
    Thanks
    39
    Thanked
    24 times in 21 posts
    /gah

    Yorkshire here...
    http://www.helpforheroes.org.uk

  13. #13
    Administrator Moby-Dick's Avatar
    Join Date
    Jul 2003
    Location
    There's no place like ::1 (IPv6 version)
    Posts
    10,665
    Thanks
    53
    Thanked
    385 times in 314 posts
    wait till you go down to visit David - I'm not far from there - failing that post on the SXOC board for one ?
    my Virtualisation Blog http://jfvi.co.uk Virtualisation Podcast http://vsoup.net

  14. #14
    Oh no!I've re-dorkalated! Jiff Lemon's Avatar
    Join Date
    Jul 2003
    Location
    Sunny MK
    Posts
    2,504
    Thanks
    80
    Thanked
    44 times in 41 posts
    I do the occasional MK to manchester M1/M62 run......

  15. #15
    My name is James J4MES's Avatar
    Join Date
    Aug 2003
    Location
    Wilts
    Posts
    1,455
    Thanks
    39
    Thanked
    24 times in 21 posts
    I'm off abroad tuesday, and the whole car thing isn't coming off atm, as the reg papers havn't arrived, so unless they get here tomorrow (fingers crossed all) then there's no roadster turbo for me (the import co. can't sell it iwthout them)

    http://www.helpforheroes.org.uk

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Second system advice........
    By madwelshboy in forum PC Hardware and Components
    Replies: 1
    Last Post: 27-04-2004, 08:46 AM
  2. Anyone have advice on building a PC for video editing
    By subucni in forum PC Hardware and Components
    Replies: 6
    Last Post: 16-03-2004, 01:39 PM
  3. HELP - advice regarding purchase needed
    By silentphoenix in forum General Discussion
    Replies: 9
    Last Post: 20-02-2004, 11:31 AM
  4. need fine tuning advice
    By savalas in forum PC Hardware and Components
    Replies: 4
    Last Post: 24-01-2004, 03:00 PM
  5. need advice about gfx upgrade...yes another one
    By alpha-prime in forum PC Hardware and Components
    Replies: 0
    Last Post: 04-12-2003, 03:37 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •