Not sure if this is in the right forum.

Was going to mod a psu but need some help please as the only mods I've done to power supplies are change the fans.

I have a Enermax Noisetaker 370w ver 1.3. This has copper shielding on the main ATX and 12V, Aux and one molex connector. On top of this there is rigid clear plastic sleeving (about 3mm thick). I was going to remove the plastic and copper sleeving so I could route the cables better in a P180 case.

I only removed the heatshrink from both ends of the ATX cable to find the black wires don't have any sleeving, i.e. they are completely bare. This explains the rigid clear sleeving along with the copper sleeving.

Questions are

1. The black wires - are these ground only? If yes, any danger if they were to touch the case or other parts?

2. If I remove the clear sleeving I am going put some tape over the exposed wires and then use heatshrink on the whole ATX connector as well as the other cables (listed above). Any problems with this apart from they won't be flexible?

3. If I use the heatshrink - is this sufficient protection for the wires?

4. Any other tips?

Thanks.