Problem with Catalyst Control Center 10.3

Just upgraded from 10.2 to 10.3 full Catalyst package (drivers and CCC). I have a 4850 as my primary card and a 3850 as my secondary, running Windows Server 2008 R2 (x64 but you knew that already). Not had any problems with 10.2 (no prior drivers, 10.2 went onto a fresh build of the system) but now when I try and run CCC (and also when the system boots) I get the following message:

"ATI Catalyst Control Center cannot be started because the currently active GPU is not supported."

We are not amused :mad:

Any suggestions??

Have you tried uninstalling and reinstalling the drivers and CCC?

Quote:

---

Originally Posted by Shad

Just upgraded from 10.2 to 10.3 full Catalyst package (drivers and CCC). I have a 4850 as my primary card and a 3850 as my secondary, running Windows Server 2008 R2 (x64 but you knew that already). Not had any problems with 10.2 (no prior drivers, 10.2 went onto a fresh build of the system) but now when I try and run CCC (and also when the system boots) I get the following message:

"ATI Catalyst Control Center cannot be started because the currently active GPU is not supported."

We are not amused :mad:

Any suggestions??

---

you got Riva Tuner installed? If so.. take it out.

What does the device manager indicate ?

I reinstalled my system but this is on the 10.2 drivers and my windows rating for gpu has gone from 7.8 2 6.9 for both graphics scores i kno the windows rating doesnt really mean much but its a bit worrying to see such a big change