My system
Nf7-S v2
XP 2500 mobile at 11 x200
1024 crucial PC 3200
new leadtek 6800 with extra pipes and vertex shaders unlocked
coreclock up from 325 to 400
memory clock stuck at 752
My question is everytime I try and push the memory frequency anything above 752 it says on test that the drivers failed to implement the new settings please lower.
Is this then the limit that this card will do as regards memory clock.
At the above settings everything is fine I get 4561 on 3d mark 05which is nearly a 1000 more than stock.It seems an unusually low memory overclock though these have been known to do 900???Temperatures are fine and no artifacts I can see or via ATI tool (after 12 minutes anyway)
I know its all in the luck of the draw and I should be glad the extra pipelines unlocked etc.Do you think it could be the drivers and a differant set might allow a higher speed on test.
A more experienced input would help as fairly new to this overclocking lark
ta
Just a thought I wonder if it is because I unlocked the pipes before doing the overclock most people I have read on the net do it the other way round?Would that make any differance?


LinkBack URL
About LinkBacks
Reply With Quote
