Originally Posted by
bobbyt
OK, I'm going to sound like a newb here, but how would I do that in the bios?
Since I don't know how to take these pics, I'll type it in for you.
Here is what I did change in the jumper free Config.
FSB 320,
CPU Ratio is 10,
DDR2-800MHZ, This should be at 640 for now You can mess around with that bit later. once you find out what your cpu can do.
Dram 4-4-4-10, and Set the ram timings and voltages to whatever they are rated at.
CPU Voltage is 1.475 which reads 1.5 in ASUS Probe. Set this to auto for now, you can change it later.
DRAM voltage is 2.20v,
These are the remaining settings set to the guide.
PCIS Freq = AUTO,
DRAM command rate = AUTO,
TWR TRFC TWTR TRRD TRTP = AUTO,
DRAM static read auto,
Transaction Booster = disabled,
CPU Spred Spectrum = disabled,
PCIE spread spectrum = disabled,
CPU voltage ref = Auto,
CPU voltage damper = Enabled,
CPU PLL voltage = Auto,
FSB Term North bridge volt and volt ref south bridge all set to auto.
Thanks again folks, consider this your contribution to helping the elderly.
BobbyT