Printable View
Before installing the new driver I could run dual monitor
After installing the new driver, whenever I boot with Dualview enabled the nvidia control panel crash upon bootup. Same happens if I enable dual view AFTER I boot.
Because the nvidia cp is dead I can't change 3D setting nor pivoting my monitor(thats what I want to do :( )
Using a 6600GT...
Did you clean out the old driver before installing the new one?
Boot into safe mode and rollback the driver to 84.21 (the 91.31 drivers are full of bugs and should never have been released IMHO)
Detailed instructions here:
https://www.microsoft.com/windowsxp/...el_july09.mspx
91.31 drivers are BETA, the 91.33 set are whql.
I had the same prob and went back to the last official 80 series whql driver and will be keeping them until the 90 series are completely sorted out.
I knew 91.31 drivers were beta but even so they shouldn't have caused as many problems as they did for me/everyone. At the moment people are better off with the older 80 series of drivers imo. When i installed the 91.31 drivers i couldn't play any video files on any media player it would lock my PC right up, the only way to get out of it was to press the reset button. I went back to the 85.96 and everything is working fine again.
91.31 first appeared as a beta driver, it's now the Whql driver on the nvidia site, i find them very buggy, try the beta 91.33 on the nvidia nzone site, might help.
Curly