Drill Part Needed For Fix

[666moe666]

Really really really struggling to find the below, which my dad needs to fix his hammer drill.

It's a three lead/terminal capacitor. I've searched high and low, even on temu, aliexpress & wish and I'm drawing a blank.

Grateful for any help where to look next, he is 77 and it would make his day if I could find it.

Needs to have the same inscriptions as far as I'm told. Have found the 0.33uF ones with smaller numbers after but not this exact one.

[Jonj1611]

Could only find it on some russian sites where I think they will be next to impossible to order from with things as they are at the moment.

The cap is made by Huaxi group - http://electronics.huaxigroup.com/en...s.asp?BigID=49

Maybe you could contact them and find out where they sell if they don't sell directly etc?

[Jonj1611]

I know its not the same one exactly but looks like you may not need the exact same one though don't take the internets word on that : https://www.elektroda.com/rtvforum/topic3353245.html

Maybe you could post on there and see if someone could give you some help locating one or even a suitable replacement

[Jonatron]

https://www.ebay.co.uk/itm/283186637569

[DanceswithUnix]

That's just an interference suppression capacitor, not a critical component (unless someone is trying to listen to the radio )

The one in Jonatron's ebay link has the right X2 and though not quite the right Y2 values, and even has a little wiring diagram on it so you an see what it's doing. I would check the dimensions on that one, and go for that if it fits.

[Jonatron]

Have found the 0.33uF ones with smaller numbers after but not this exact one.

Sorry, didn't read! I can't imagine a small difference in pF making much of a difference, I wouldn't bother trying to find an exact match, just the closest you can.

[666moe666]

Cheers guys, very thankful for all the advice. Will purchase and report back!