beep code after building pc

Hey i just finished building my machine. But it gives me a beep error.

I get one long beep followed by four short beeps then a slight pause followed by one additional beep. Could not find out what the beep means though.

The mother board is a Maximus VI Hero.

Please help.

http://www.asus.com/Motherboards/MAX..._HERO/#support

Ask Manuel. (won't open for me at work)

http://i.dailymail.co.uk/i/pix/2008/...77_224x423.jpg

Difficult to know which codes the UEFI bios uses. some here but difficult to know which one.

http://www.bioscentral.com/beepcodes/phoenixbeep.htm#

Sounds to me like your memory timing failed. First 64 KB RAM address line failure.

AST Phoenix BIOS
Beeps Descriptions
1-1-3 CMOS read/write failure
1-1-4 ROM BIOS checksum failure
1-2-1 Programmable interval timer failure
1-2-2 DMA initialization failure
1-2-3 DMA page register read/write failure
1-3-1 RAM refresh verification failure
1-3-3 First 64 KB RAM chip or data or data line failure
1-3-4 First 64 KB RAM odd/even logic failure
1-4-1 First 64 KB RAM address line failure
1-4-2 First 64 KB RAM parity failure
2-1-1 First 64 KB RAM failure bit 0
2-1-2 First 64 KB RAM failure bit 1
2-1-3 First 64 KB RAM failure bit 2
2-1-4 First 64 KB RAM failure bit 3
2-2-1 First 64 KB RAM failure bit 4
2-2-2 First 64 KB RAM failure bit 5
2-2-3 First 64 KB RAM failure bit 6
2-2-4 First 64 KB RAM failure bit 7
2-3-1 First 64 KB RAM failure bit 8
2-3-2 First 64 KB RAM failure bit 9
2-3-3 First 64 KB RAM failure bit A
2-3-4 First 64 KB RAM failure bit B
2-4-1 First 64 KB RAM failure bit C
2-4-2 First 64 KB RAM failure bit D
2-4-3 First 64 KB RAM failure bit E
2-4-4 First 64 KB RAM failure bit F
3-1-1 Slave DMA register failure
3-1-2 Master DMA register failure
3-1-3 Slave interrupt mask register failure
3-1-4 Slave interrupt mask failure
3-2-4 Keyboard controller test failure
3-3-4 Screen memory test failure
3-4-1 Screen initialization failure
3-4-2 Screen retrace test failure
3-4-3 Failure searching for video ROM
4-2-1 No timer tick
4-2-3 Gate-A20 failure
4-2-4 Unexpected interrupt in protected mode

http://www.technick.net/public/code/...ide_beep_codes

Have you tried the MemOK! button? What LEDs are lighting up on the board? (it has 4 diagnostic LEDS in a stupid place that are probably hidden by the ATX 24Pin connector.

Edit: or indeed the QCode display on the board, that has a huge list of error codes in the manual.

It turned out it was "CPU Fan Error". The RPM of the fan was 600 the Mobo gives warning on 650 or lower. So i lowered the warning number. Temps are still avg 20 C on each core with such low RPM so it seems ok :)

Thanks guys.