Hi,
I'm trying to set up a IPSEC VPN from my Draytek Vigor 2710n to my office which is running a NETGEAR ProSafe VPN Firewall FVS336GV2.
The router logs are giving me this (ip address has been replaced):
2013-03-09 16:33:18 local1.notice Vigor: Dialing Node1 (RRC) : xxx.xxx.xxx.xxx
2013-03-09 16:33:18 local1.notice Vigor: Initiating IKE Aggressive Mode to 212.169.52.114
2013-03-09 16:33:18 local1.notice Vigor: IKE ==>, Next Payload=ISAKMP_NEXT_SA, Exchange Type = 0x4, Message ID = 0x0
2013-03-09 16:33:19 local1.notice Vigor: IKE <==, Next Payload=ISAKMP_NEXT_SA, Exchange Type = 0x4, Message ID = 0x0
2013-03-09 16:33:19 local1.notice Vigor: NAT-Traversal: Using draft-ietf-ipsec-nat-t-ike-02/03, no NAT detected
2013-03-09 16:33:21 local1.notice Vigor: IKE <==, Next Payload=ISAKMP_NEXT_SA, Exchange Type = 0x4, Message ID = 0x0
2013-03-09 16:33:21 local1.notice Vigor: NAT-Traversal: Using draft-ietf-ipsec-nat-t-ike-02/03, no NAT detected
2013-03-09 16:33:27 local1.notice Vigor: IKE <==, Next Payload=ISAKMP_NEXT_SA, Exchange Type = 0x4, Message ID = 0x0
2013-03-09 16:33:27 local1.notice Vigor: NAT-Traversal: Using draft-ietf-ipsec-nat-t-ike-02/03, no NAT detected
2013-03-09 16:33:29 local1.notice Vigor: IKE <==, Next Payload=ISAKMP_NEXT_SA, Exchange Type = 0x4, Message ID = 0x0
2013-03-09 16:33:29 local1.notice Vigor: NAT-Traversal: Using draft-ietf-ipsec-nat-t-ike-02/03, no NAT detected
Does anyone know where I'm going wrong?
Thanks
Sam