Dear All,
Has anyone with the following combination E6600 & AW9D-MAX been able to hit 3.6Ghz on aircooling and stable if so what were the voltages for cpu ddr and mch and temps after overclock?
Many Thx
Printable View
Dear All,
Has anyone with the following combination E6600 & AW9D-MAX been able to hit 3.6Ghz on aircooling and stable if so what were the voltages for cpu ddr and mch and temps after overclock?
Many Thx
I have I think what is to be considered a good chip.. and mine wont stay stable at that..only time i got close it was running way too hot on a high vcore
I got my E6600 @ 3.3Ghz (367 x 9) and use 1.4V on the CPU and 2.0V on RAM (G-Skill 6400-NR 2 x1Gb). I'm running a DS3 with F7 bios. My temps are good - CPU is never above 50C even on load in a warm room.
I also upped some of the board voltages as suggested by +0.1V
Had mine running at 3.6 with 1.4vCore and 1.55vMch, but had to back it off as temps were just too high..... 70+ at load
Yeah, you did have higher vCore and very high vMCH. The voltage is where all the heat comes from