Urgent help with my new build please (RAID BSOD)

I have put together my new PC, relevant spec as follows:

Gigabyte GA P35C-DS3R
Intel Core 2 Duo E6750
2 x 250 Gb Samsung SP2504C SpinPoint (RAID)
Samsung SH-S203B 20X DVD±RW/RAM

I have plugged the drives in as follows:

http://www.chrismox.ukfsn.org/gigabyte.JPG

In the BIOS, I have set the following:

BIOS > Integrated Peripherals > SATA RAID/AHCI Mode (Intel ICH9R Southbridge) > RAID
BIOS > Integrated Peripherals > SATA Port0-3 Native Mode (Intel ICH9R Southbridge) > Enabled
BIOS > Integrated Peripherals > Onboard SATA/IDE Device (GIGABYTE SATA2 Chip) > Disabled **Nothing plugged into it**

I've then setup the RAID stripe in the Intel menu that appears.

When I try to install XP, I press F6 to install the drivers (from Gigabyte's site) and select "Intel (R) ICH9 SATA RAID Controller (Desktop ICH9R)" as mentioned in the manual.

XP setup continues to load a few files and the says "Setup is starting Windows" followed by a BSOD with the following code: "*** STOP: 0x0000007B....."

I have tried the disabling RAID and everything works fine.
I have tried the Gigabyte RAID controller (plugging the drives into the pink sockets instead) and everything works fine.

So, what am I doing wrong?

Do the hard drives have to be on a different controller to the DVD drive when using RAID?

I'm at a loss, any help much appreciated.

I'm not familiar with the layout of that board, but are you sure that you havent got the drives plugged into the jmicron sockets?

I think the pink ones are the jmicron ones, the orange ones are the Intel ones.

I've made some progress, seems the manual is wrong and the driver I need is not actually on the disk... Choosing the "Intel (R) ICH8R/ICH9R SATA RAID Controller" has potentially solved the problem.

try plugging the dvd drive into the jmicron ports