Mobile Barton's

[NeilI]

2.3 ghz at 1.5 volts rock solid.

What sort of temperature will that be running at?

[Mr Meltdown]

AT the time I had a DFI Ultra2 wotnot and my trusty KD7 and it worked fine in both. But basically if there is an "issue" between a motherboard and running these then I#d suggest to just blow the 2nd to last L5 bridge (next to the MP bridge) as this is what tells the CPU and your motherboard the CPU is a Mobile part. It will then be a desktop CPU again and should run.

2.3Ghz @ 1.5V using an SK6 copper and a slow 92mm fan = VERY quiet.

Temps: dunno, I use my finger as a guide. ANything above a warm to the touch feel and I start to fret.

CHeers,

MM

[Spritzup]

Well my barton at stock will run at about 38 full load, so I suspect it would be less than that