Printable View
I've put my system together today and upon boot I get stuck on code 75 (Sata problem). I have tried different cables, boot with 1HDD only, 1HDD and DVD and it just gets stuck.
I have reseat all cable and using only 1
System
DFI LanParty P45T2RS Plus
2 x Samsung 640Gb
1 x Smasung 1TB
1 DVD rom
Q6600
Ninja II cooler (I pain to fit in the mobo)
Corsair 520W Mod PSU
When I managed to access the BIOS it had detected all HDD and DVD rom
help/ideas are appreciated
Check the HDD power cable is in properly. Does it get to the BIOS with no SATA or PATA devices plugged in?
i kinda of reseat the cooler, do i need to clean up cpu heatsink and re-apply paste. I am a bit lazy tbh
all cables are securely connected
The HDDs came without jumpers. Do I need to setup jumpers on these drives???
:wallbash:
Does it get to the BIOS with no SATA or PATA devices plugged in?
Even with all sata devices disconnected the mobo gets stuck on POST 75 (sata problems). DOA????Quote:
Originally Posted by Clunk
looks like a DOA
Try removing the battery for a few mins then try again with no devices connected.
Some progress, i was able to get into the BIOS. I am thinking of falshing with the latest BIOS, as there is an issue addressed by this new BIOS: 2. Patch for JMB363, JMB368 and ICH10 SATA not in native mode hang"75".Quote:
Originally Posted by Clunk
It's not actually fixed it. If you disable the JMicron controller it still hangs on error code 75 with the latest BIOS.Quote:
Originally Posted by pardal51
Not user friendly board setup at all
Plugged only 1 HDD
Installed OS on a single connected HDD.
Plugged the remaining HDD
Downloaded Intel Matrix Storage Manager driver/utility
Rebuilt the RAID 1 array
So far it seems to be working okay.
Special thanks for Clunk for the battery tip :bowdown: