My feser one has a lot of air dissolved into the fluid.
I have had an air lock, which I have finally removed but I can still see the air bubbles moving around.
Is this normal
All help appreciated
Thanks
Printable View
My feser one has a lot of air dissolved into the fluid.
I have had an air lock, which I have finally removed but I can still see the air bubbles moving around.
Is this normal
All help appreciated
Thanks
I've used diluted feser one in my system and found that the bubbles went after about a week of use.
For the first few days bubbles and cloudiness were quite abundant.
This has been like this now for 2 weeks and is not getting any better.
Odd....is it neat or diluted?
No its neat (pre mixed)
now the air locks gone it will take a while to shift them all, make sure its not on 24/7 or they wont get a chance to settle
The other change, is swap a swiftech reservoir from a version 1 to a 2. Could this be a problem?
well u need to make sure its topped up or air will keep getting back in
jump start psu (or use spare psu for pump only) so only pump running (PC not on)
top the res up completely
tilt the case around
vary the flow (pump on & off and pinch tubing)
Never let air get sucked from the res into the pump or you are back to square one again.
Thanks for the advise but I have done this. I think the feser is so air-rated that I will have to drain it down and start from scratch. :crazy:
can you list your components order, or better still, post a photo - there might be something making this more difficult than it needs to be.