Vengeance or Corsair Dominator GT

Since my new sandy bridge setup is arriving soon, which ram shall I get?

a) 8GB (2x4GB) Corsair Vengeance DDR3 PC3-12800 (1600), Non-ECC Unbuffered, CAS 8-8-8-24, XMP, 1.50V

b) 8GB (4x2GB) Corsair Dominator GT, DDR3 PC3-14900 (1866), CAS 9-9-9-24, DHX, XMP, DF, 1.65V

c)8GB (4x2GB) Corsair Dominator GT, DDR3 PC3-14900 (1866), CAS 9-9-9-24, DHX, XMP, DF, 1.65V

Vengeance 1600. The extra speed of the dominator will make absolutely no difference at all. In fact, in benchmarks the only difference found is theoretical... I'd gladly take the extra money off your hands rather than you throwing it down the drain ;P

Quote:

---

Originally Posted by Ultima2876

Vengeance 1600. The extra speed of the dominator will make absolutely no difference at all. In fact, in benchmarks the only difference found is theoretical... I'd gladly take the extra money off your hands rather than you throwing it down the drain ;P

---

Depends how much money your asking for ;D

Also, Sandy Bridge prefers 1.5V to 1.65V

Quote:

---

Originally Posted by Skulltrail

Also, Sandy Bridge prefers 1.5V to 1.65V

---

I've heard about that but I've seen people use 1.65v and its been fine :o
plus on the motherboard manual, it say's it can be used :o

Heard a few good things about the G Skill Ripjaw's "built for Sandy Bridges" type sticks? They're fairly cheap too.