Life After water?

[mr_anderson187]

ok so my watercoolign arrived, the thermaltake aqaurius 2 one that i had the threead about recently, my nfs ver 2 mob also arrived, so i set the watercooling up, im currently runnign thsi sweet nfs board btw, so i ahve the watercoolign set up and the water is zipping round and there is onyl a few wee bubbles in the pipes leading form the pump, cpu and radiator, but a fiar few around thios backup tanks which doesnt seem to be in the loop of coolin so im not worried bout that
the cpu block however feels as cold as it was beofre i turned it on lol, althio can feel water going thru it, cos of liek slight vibrations and stuff, it feels cold, is it safe to put this in my system? like is ther anything i ahve done worng cos i dont wana burn out my 1700 cos of a stupid eager mistake

is this safe guys, and how long wood it take to burn out a cpu iif this thing was bum? e.g. how long have i?

[SilentDeath]

You should bee more worried about it leaking :E

If its mounted properly, the pum and fan are on, then you shouldnt have problems.. just watch your temps in mbm or bios.

[mr_anderson187]

lol i just slapped it in booted it up and its sitting at 23 degrees not bad, and not loud but how du guys get 2.3 outa ure 1700's? is ther like a ocing guide to this, ive fiddled about but i dont wana go burnign sumthin again after spennding the best part of 4 hours to get this mobo to go, lol, its a lonmg way off from the old asus a7v8x-x mobo i used to have

[unrealrocks]

There are only some 1700XP chips that'll manage 2.3Ghz

Cool - the aquarius setups are ment to be good extreme budget WCing systems

[mr_anderson187]

itrs runniong at 23 degrees with the wee jippy fan on the radiator, i can stick a really powerfull fan on it and lower it a bit more i think,, i coudl get my 1700 over 2.1ghz on my asus a7v8x-x mobo, isnt it the juihb ones thjat can get 2.3 i think thats wot mine is so i should be able to get it, but its just wont boot when i try to overclock at all, what multiplier fsb and voltage you guys usign for this, expecially you buff, you have 2 of these boards

[Flash]

you need to up the volts matey to get them sorta speeds

1.9v isnt uncommon but be careful go up in increments

[BUFF]

isnt it the juihb ones thjat can get 2.3 i think thats wot mine is so i should be able to get it, but its just wont boot when i try to overclock at all, what multiplier fsb and voltage you guys usign for this, expecially you buff, you have 2 of these boards

11x209 @1.85V it's a JIUHB DL3TC

If I can refer you to http://www.hexus.net/content/reviews...hpc3Rvcnk9LTI=