Spec me some water cooling!

[DannyM]

Hi Folks,

Hope everyone is well!

I've got an itch and my 290x is like a volcano waiting to errupt! I'm wanting to water cool my CPU and GPU below is a spec I've put together, could somebody please check it over and advise me if there are any alterations I need to make (I'm getting my GPU plate off of eBay).

Is it worth going to a cheaper all in one kit that some websites offer?

[herulach]

You'll want some 45/90 fittings, probably a 90 into the gpu, 45s between gpu and cpu then angles on the rad depending where you mount it. I'd also go for a D5 based pump setup if you want a tube rad, mostly because they fit nicely together. What case is it going in?

[DannyM]

You'll want some 45/90 fittings, probably a 90 into the gpu, 45s between gpu and cpu then angles on the rad depending where you mount it. I'd also go for a D5 based pump setup if you want a tube rad, mostly because they fit nicely together. What case is it going in?

I'll double check fittings before purchasing. I need to plan the layout a bit more.

I haven't planned to spend loads I would like it to be fairly cheap, I'll look into the pump more.

It's going into a Thermaltake V21.

http://www.thermaltake.com/products-...?id=C_00002559

I'll look to add an extra rad in the future and I already have some fans for the rad I'm going to purchase.

[jamiehard1989]

I would get a ddc pump with small res as a d5 mite not fit in the case as it bigger.

Have a look on wcuk, candccentral.

I would go for 10/13mm tubing


Sent from my iPhone using Tapatalk