IDE ? Master / Master or Slave and Master?
Buying some Rounded cables for my 2 CD drives (1 is a Pioneer 106 – Other is a Liteon). I initially wanted to set both drives to Mater using the Primary and Secondary IDE ports on my Motherboards, as my Hard drives are SATA, so I can take full advantage of these. I cannot find any Rounded single connector IDE cables, my options are buying two, two connector cables and just hiding the additional connector.
Or shall I just use one cable and set one to Master and one to Salve? Does this have an effect on Performance?
Re: IDE ? Master / Master or Slave and Master?
Quote:
Originally posted by suki_uk
Buying some Rounded cables for my 2 CD drives (1 is a Pioneer 106 – Other is a Liteon). I initially wanted to set both drives to Mater using the Primary and Secondary IDE ports on my Motherboards, as my Hard drives are SATA, so I can take full advantage of these. I cannot find any Rounded single connector IDE cables, my options are buying two, two connector cables and just hiding the additional connector.
Or shall I just use one cable and set one to Master and one to Salve? Does this have an effect on Performance?
Yes it would have a small affect.
However you can buy them from here;
http://www.kustompcs.co.uk/product.p...02c7e9e0adde89
Re: IDE ? Master / Master or Slave and Master?
Quote:
Originally posted by suki_uk
Buying some Rounded cables for my 2 CD drives (1 is a Pioneer 106 – Other is a Liteon). I initially wanted to set both drives to Mater using the Primary and Secondary IDE ports on my Motherboards, as my Hard drives are SATA, so I can take full advantage of these. I cannot find any Rounded single connector IDE cables, my options are buying two, two connector cables and just hiding the additional connector.
Or shall I just use one cable and set one to Master and one to Salve? Does this have an effect on Performance?
make your own? just cut the end one off done it before and it was fine