Printable View
Hey All,
Currently running an Barton 3200+ with 1.5gb DDR-400 and a GF 6800 (unlocked to gt). Was having a play last nite with clockgen, and the minute i upped the fsb to 220, (even though previously this had been no problem) i get a BSOD. The only thing that has changed is the GFX card, so that shouldnt be a problem?
Anyway as a sidenote what voltages should I be running (NF7-S v2)
CPU 1.8v
RAM 2.6v
Chipset 1.6v
Agp 1.5v
They about right?
Cheers
Dave
Try remove one of the 512M stick. It is very hard to overclock with 3 sticks in.
Without knowing what RAM 2.6Vdimm at 220 strikes me as low.
cpu/ram ratio?
1:1 or eqivalent. Buff, never had to change voltage before on such as small increase?
If it's PC3200 that's a 10% increase on stock so imo that's not a small increase.
Are these Voltages the settings in BIOS or as read by sensors?
& your PSU is?
Theyre set in the bios, measured by the ntune gadget. When I said small increase I meant for the proceesor, it goes from 2.2 to 2.4ghz, didnt occur to me to think of it that way :Oops: My PSU is a Hiper Type-R 480w
Dave
Is your AGP bus is locked at 66Mhz. Turn off fast writes. What does your BSOD say?
erm pass? it auto reboots, and the agp bus should be locked, was last time I checked.