Noob Clocker

[poindextermatic]

Hi, am just trying to tweak my system a little and can't seem to figure out why it won't work.
Have a AMD 64 3200+ sock939
Have upped the voltage a little and then turned the frequency up by 5%

When I used 'cpu-z' it says it is only at 2010MHz? Surely this should be 2100?
Do i need to change the multiplyers?
Multi = 10
HTT = 201.0MHz ??

Any hints would be welcome,

Cheers.

[RDL]

ehrm - 10 x 201 = 2010 mate

Adjust the HTT and lower the multiplier a bit more if you want (depends how far you want to push it, what your cooling is etc.)

Also, make sure you have the PCI lock on, can save a lot of hastle.

[teachmech]

Try reading some of the following threads
http://forums.guru3d.com/showthread.php?t=139322
http://forums.guru3d.com/showthread.php?t=122731
but as poindextermatic said lower the HTT and raise the "fsb" 10 at a time and check with something like prime95 for stability.
raise "fsb" to 210 x 10 = 2100