N299 RAID1 auto rebuild

[bgougis]

Hello,

Firmware version 1.0.0.26
2 seagate HD500

After replacing a damaged drive (disk1), the N299 doesn't want to start the auto-rebuild function.
The status of the disk 1 is unused.
In the RAID configuration, if I create a RAID, I'll loose all the data in the disk 2.
How can I rebuild the RAID without loose my data ?

Best regards

[Thecus - Yvon]

Dear Sir,

For RAID1, if we replaced the HDD already, We just need check this new HDD from STORAGE->RAID->CONFIG->check the HDD->APPLY/CREATE to rebuild this RAID1 volume.