Flash Disk

[geobest]

Hello,

one maybe stupid question,

How i can access the directories on Flash Disk on a Thecus N5200 Pro ?

Can i with FTP and How ?

Thanks In Advance
Giorgos

[Funkstar]

Under normal curcumstances you can't.

You could try the SSH module though.

http://www.onbeat.dk/thecus/index.ph...0_Module:_SSHD

[geobest]

Thanks Funkstar

Let's change a litle bit the question,

How can i have access to flash disk of Thecus N2500 Pro from my pc to make some changes?

thanks

[Funkstar]

Ah, ok

The connector looks like a CompactFlash connecter if I remember right, so attaching it to a CF-> IDA adapter should do the trick. or a 1.8" to 3.5" ide adapter perhaps.

Whatever you use, it should be recognised as a regular drive in the bios and mountable under linux.

[geobest]

the Connector is 44pin IDE 2.5 connector.

i Connect to a 2.5 Case for laptop disk and i copy to the pc .

[Funkstar]

Is it? oh well, I remembered it was smaller than that. Obviously i was wrong.

[geobest]

I make a mistake !!!

Today i recieve the Transcend 8GB IDE Flash Module 44Pin Horizontal (TS8GDOM44H-S) but i cannot connect to a 2.5" Hard Disk Case.



Can anyone help how can i connect to pc the Flash Module

I want to connect the original Flash Module of Thecus N5200 Pro, make an image and then to Connect the new one to restore the image.

After i put the new one to Thecus N5200 Pro.

[Funkstar]

Like I said, I was sure it was a 1.8" interface.

This should work: http://www.b2cshop24.com/en/35-ide-t...l?currency=GBP

[geobest]

Back again with the Solution !!!!

The interface of IDE Flash Module is 2.5" but,

Transcend 8GB IDE Flash Module 44Pin Horizontal (TS8GDOM44H-S) has Female Connector.

The 2.5" HDD's has Male Connector.

All 2.5" Cases has Female Connector !!!!

I order that : 44-pin 2.5 IDE Laptop Male to Male Cable 4cm

[Funkstar]

Ah, yeah, I didn't think of that

[pit234a]

but, when I asked for modification on that, I got an answer like, filesystem on the card would be crypted. So, there would be no chance to do modufication on the card.

Please, could you verify that you can access the files on the CF-Card directly and change them?