IP35Pro no signal to monitor(new Ram)

[nowak19]

Hello,

I just came home from the store and powered down my PC and disconnected the power. I inserted the 2 new sticks of ram and my monitor is getting "No Signal." The old Ram specs are: OCZ PC2 6400 1gb dual channel 4-4-4-15 while the new ram is OCZ PC2 6400 2gb dual channel 4-4-3. I have the old rams in slots 1 and 3 while the new ones are in slots 2 and 4. I am getting 9.0. showing up on the motherboard uguru light. It seems to start and run fine but there is nothing coming up on the monitor. It is running but nothing is showing up! Please help! My USB keyboard and mouse are not lighting up either. I have tried to boot up with the old memory and flashed the Cmos1. Any help would be greatly appreciated!

Chris

[GoNz0]

check you havn't knocked anything loose, try 1 stick of ram in each slot and reset the bios betwen boots

[format]

You could also try resetting the CMOS.

[BUFF]

checked RAM voltage required & set?
also possible that you may need to slightly increase Vmch.

[nowak19]

I can't do anything in the bios because there is no signal going into my monitor. I can't see anything from when I push the power button to turn it on.

[GoNz0]

u reset the bios on the motherboard, time to get the manaul out and read it

[nowak19]

OK...I don't quite know what you meant by that but there is nothing further in the manual. I do know how to reset the cmos. There is no further explanation within the manual. I have tested another monitor as well and it receives no signal.

[BUFF]

I can't do anything in the bios because there is no signal going into my monitor..

have you tried with only 1 DIMM installed?