IP35-E with G.Skill DDR2-1066 1Gx2

**jacky400** · 01-09-2009, 01:04 AM

Can IP35-E support DDR2-1066 ? becasue when i plugged a pair of DDR2 1066, it cannot boot up

DDR2-800 is fine .

**BUFF** · 01-09-2009, 01:15 AM

what CPU are you using & how have you got your RAM configured (CPU : RAM ratio, voltage etc.)?
have you tried installing 1 DIMM, then setting up manually, save & shut down, install 2nd DIMM?

**jacky400** · 01-09-2009, 01:19 AM

CPU is E5200 with latest bios 1.8 .

Tested RAM is G.Skill DDR2-1066 1Gx2 .Already tried to install in DIMM 1 or 2 or 3 or 4 .All failed to bootup .

Same cpu votage/RAM ratio for DDR2-800 and bootup fine.

clear CMOS also not helping

**BUFF** · 01-09-2009, 02:04 AM

have you tried running with 1 DIMM?
Have you increased the RAM voltage to that recommended by G.Skill (normally 2.0-2.4V depending on which series of RAM).
E5200 is 800fsb (4x200), DDR2-1066 is 2x 533 so you need a ~200: 533 CPU:RAM ratio & it possibly doesn't have something close.

G.Skill normally plays very well with IP35 series mobos.

**jacky400** · 01-09-2009, 02:38 AM

thanks Buff . i will try again tonight to set RAM ratio to 1066 and voltage to 2.2V

Thread: IP35-E with G.Skill DDR2-1066 1Gx2

LinkBack

Thread Tools