Been working on my first build, and I've run into an interesting problem with the front panel connectors of my Antec 300 Illusion case. The link below is a picture of the cables I have to work with; sorry about the inconvenience, but I am unfortunately restricted from posting the image directly with the [img] tag due to having less than five posts on this forum. Just remove all the spaces.

h t t p : / / i . i m g u r . c o m / b 3 S f w . p n g

The manual mentions a cable labelled "POWER SW", but as seen from the picture above this cable simply does not seem to exist. At first, I made the assumption that the two-block "POWER LED" cable was the one I needed and simply mislabeled, but this didn't work.

Then came the weirdest part; I found somebody saying that the reset and power cables had been reversed in the 300 Illusion, so I tried swapping the respective cables and turning it on. Nothing doing. However, when I powered the computer up through the motherboard (MSI P67A-GD53 B3 if it matters) and tried turning it off using the power button, it reset the computer, and the reset button powered down the computer completely. Attempting to power the computer back on using the reset button did not work.

Given that the computer boots up perfectly fine using the motherboard's power button, I'm fairly certain the cables themselves are at fault here, but I'm ready to be told otherwise. Can anybody give me a hand?