.. to replace my 6099?
basically it's a PC-6099 but it is slightly "deeper" to allow a dually mobo fit into the case.. thinking of getting the 6299 so that I'll have more room to play with watercooling![]()
what you think?
.. to replace my 6099?
basically it's a PC-6099 but it is slightly "deeper" to allow a dually mobo fit into the case.. thinking of getting the 6299 so that I'll have more room to play with watercooling![]()
what you think?
Last edited by overfloe; 30-11-2003 at 08:58 PM.
PC70 would be a better option if you're serious about more space for watercooling![]()
Yeah I'd spend that little bit more on the PC70/75. That case has so much room inside it you can fit watercooling and a lot more.
no, not full tower.. never for me..
mid is big enough for me..
Well, I have no problems fitting:
Thermochill 120.2 (with 2 papst 4312 L jobs on there)
aluminium drinks bottle (holds 2 pints)
Eheim 1250
danger den z chipset
danger den maze 4 coppertop
and plenty of 12mm tygon
all in my PC60. It's a little cramped, but as long as you make everything tidy, measure out your tubing properly, and plan the placement of each component before you put it in, you won't have a problem. Perhaps do a feasibility test with different kit measurements etc (to make sure certain components will fit).
Hope that helps a little![]()
thanks Theo..
im using Tank-O-Matic res.. currently it sits outside of the case (at the back), but if i use a "longer" case I'll be able to fit the res inside the case, on the mobo tray![]()
There are currently 1 users browsing this thread. (0 members and 1 guests)