Since building my system I have noticed two problems that happen on a cold boot:
1. When I press the power button, the system will start up for 1 second. Then power down for a further second and then power up again and resume POST test and XP startup. All of this takes place in about 3 seconds.
2. Just before XP startup (XP logo sequence), my monitor will go blank and then go into standby mode.
I have checked the power supply readings and they are as follows:
VCORE: 1.23v
3.3V: 3.31v
5V: 4.96v
12v: 12.09v
The readings look fine to me. Any ideas or advice appreciated on this problem.
Regards,
RM