What to do with Molex fan conectors?

[watercooled]

I have an Antec 900 case which has 4 fans, all of which have a Molex power connector. At the moment, I have all 4 chained together and crammed into a spare drive bay. It does work OK, but it's untidy and a real pain when I'm working inside my PC - I've give my heatsink and gfx card a few whacks disconnecting them. What can I do to tidy things up a little? I was thinking some sort of junction box but at least the front two fans must be detachable without the need for a soldering iron. Was also considering a fan controller but since the fans are tri-cools and have speed selectors already attached, this would probably only make things worse.
Thanks again!

[Viper81]

Have you got any spare fan headers on your motherboard? If so you could use molex to 3-pin convertors to connect them straight to your motherboard.

[watercooled]

I only have 2 free but have 4 fans. There is a side panel window however, and this would look untidy. Thanks all the same

[thunder12]

ah there are loads of tips for cable management. PM me if you want me to PM you pics of my A900 and how i have set it up

Thunder

[moogle]

ah there are loads of tips for cable management. PM me if you want me to PM you pics of my A900 and how i have set it up

Thunder

Post it here!

[thunder12]

This isnt my A900 coz i cba to take pics haha. Mine looks practically the same as these two pics. You just need to utilise the space on the back panel as much as possible.

Thunder