Hi All,
I have had this board about a week, and have muddled through a couple of issues, flashing v16, and not having video, re-flashing to v13 blind, and back again v16. I am up and running a dual boot XP Professional and Vista Ultimate 64-bit.

Here is my setup:
Pentium 4 630 (3.0Ghz 15x200Mhz) (will be adding e4300 next week from another machine)
4gb OCZ2G8002GK 4x1gb sticks DDR2-800 (2.1V) 5-5-5-5-12
Seagate 320gb Barracuda SATA

I have been able to get into the BIOS to up the DDR Votage to 2.1V, set the Ram by SPD, and manually. Going through this process, I have managed to get 3 sticks of the ram to run at 400MHz (DDR2-800), but cannot but the 4th stick in or I get a garbled POST screen and it freezes and won't POST. I have tried setting the memory speed slower, NB voltage up a little (1.9 max), memory voltage higher........(all suggestions from the OCZ folks, I have switched the sticks around, and it doesn't seem that any one stick is responsible for the issue)

Any suggestions?
I like the board so far, and would be completely satisfied it I could get the 4th stick to run.

Thanks,
Rob