Uguru giving me strange warnings

[DaveNC]

see the attached. What could be causing this?

[Tetras]

It appears you have set (or it set incorrectly) the PWM temperatures to alert you at 0.0c, so it is pretty likely they will reach the warning temperature.....

From the red highlight on the fan tab it is likely the same has happened there but for RPM.

[DratUK]

Just click on setup in Uguru and click each indicator on the left and set you parameters or just hit default settings
in the Abit EQ menu.

[DaveNC]

What about the CPU Voltage being disabled? Also, I haven't done anything to the settings, I'll go in and hit default and see what happens. I'm having some start up issues as well. Since I am still building the rig(no, I'm not on it now), I do some work and the unplug it and set it aside. Then when I go back in to plug it in, it either just clicks or cycles on and off. I am being to think I have a bad PSU. I do not have anything plugged in to the system fan connection, what should be plugged in there?

[BUFF]

just reset uGuru, it's having a bad day

[Tetras]

If the CPU voltage was disabled it wouldn't boot... it just means it isn't monitoring the voltage.

I do some work and the unplug it and set it aside. Then when I go back in to plug it in, it either just clicks or cycles on and off.

Are you turning the rig off at the PSU or the wall?

[DaveNC]

PSU then unplugging it. Seems to be ok now. I reset the defaults and all is well. Not very good documentation on Uguru. If anyone has any tutorials, I'd love to see it.