Antec NeoPower voltage problem

[PanzerKnight]

hey there

Just recently installed my new antec neopower, but when i start my motherboard software the alarm goes off. Seems the minus -5v voltage is alway up to 3.55v



Anyone have any clues what could be causing the problem?

Thanks for any help guys!

[bmh.01]

Not sure whats causing the low -5v reading but your voltages in general look a bit low. What wattage is the psu ?

[Shogun]

Its prob the sensor wired up to the wrong bit, don't worry about it.

[PanzerKnight]

its a 480w
ok will try leaving it for a few days to see if anything dodgy happens