Results 1 to 6 of 6

Thread: PSU question

  1. #1
    Registered+
    Join Date
    Sep 2003
    Posts
    46
    Thanks
    0
    Thanked
    0 times in 0 posts

    PSU question

    Hi again chaps, I was recently given a low noise 300W PSU, I have two questions:

    will it be beefy enough to power a new system i'm putting together (basically an AMD Barton running on an NF7 v2.0 Nforce2 mobo)? or should i be thinking more along the lines of 350-400W?

    secondly to test the psu i simply powered it up to the mains, the psu's internal fan did'nt come on, no power? is this simply because its not physically attached to any peripherals?

    advice most welcomed

  2. #2
    Senior Member schrickvr6's Avatar
    Join Date
    Jul 2003
    Location
    Da'port
    Posts
    990
    Thanks
    1
    Thanked
    1 time in 1 post
    what brand is it?some 300w will run it fine but then again some cheapy 400w could pop in minutes

  3. #3
    Banned
    Join Date
    Sep 2003
    Location
    Midlands
    Posts
    8,629
    Thanks
    24
    Thanked
    260 times in 181 posts
    From what I've been led to believe, its more about the brand, and the quality of, than the power.

    I'm sure most, if not all people on this forum, would take a 350w Antec, Enermax, Sparkle, or other quality PSU, over a 550w cheapo model, such as a Q-Tec, or similar.

  4. #4
    Senile Member
    Join Date
    Dec 2003
    Posts
    442
    Thanks
    3
    Thanked
    0 times in 0 posts

    Re: PSU question

    secondly to test the psu i simply powered it up to the mains, the psu's internal fan did'nt come on, no power? is this simply because its not physically attached to any peripherals? [/B]
    Yep.

  5. #5
    Senior Member schrickvr6's Avatar
    Join Date
    Jul 2003
    Location
    Da'port
    Posts
    990
    Thanks
    1
    Thanked
    1 time in 1 post
    get a 2 or 3" piece of wire and connect the green wire and the black wire 2 wires away on the atx connector,they will be either side of the retention clipthis gives the psu a signal to power up

  6. #6
    Registered+
    Join Date
    Sep 2003
    Posts
    46
    Thanks
    0
    Thanked
    0 times in 0 posts
    thanks for the advice so far guys, the psu in question is a 'Q Technology' ATX-1125BTA QT 300 Watt, any good?

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •