Fatil1ty an9 32x Motherboard

[deathdeeler]

I have been running this motherboard for 4 months then all the sudden I had a power outage.

Now my cpu keeps giving me a 9.9 error.. Please finish power of cycle.

Thought maybe my Power supply went out. Bought new one and same issue.. starts up for 6-8 secs
then starts beeping.

took it apart to bar bones it went to code 8.4 and shut off.
I have OC PC 6400 ram 1gig duel sticks in..
Keep seeing how OC may not work.. Well mine did work for 4 months.

I put just 1 stick in and graphics card 7600 Geforce. and it booted fine went to windows and ran great
but only had 1 stick of ram in it.. so i went to setup checked to see if all setting were good. they looked fine. so powered off and put other stick back in Now its back to LOL error 8.4 then to error 8.7....cant even do just 1 stick of ram lol.. Please and suggestions would be nice..

[BUFF]

9.9. just means that he mobo has finished it's shutdown sequence - it's the codes before that that may give a clue as to the problem.
What PSU did you have & what did you replace it with?

Try clearing CMOS & then with only 1 DIMM installed see if it will boot.
If it does check the RAM voltage - it probably needs to be ~2.0V for that RAM to run at it's rated speed & it may have defaulted back to the JEDEC spec. 1.8V.

[deathdeeler]

get 2 but its in the _2 so second part of post bar..no Dots..
then goes to 8.4
LOL now its going to 8.C. and Staying
Tried to Clear CMOS

no work.

[BUFF]

what PSUs have you tried - in fact a full system spec. would be useful.

[deathdeeler]

3200 amd
2x 1gig OC pc2 6400 dual ch platinum edition xtc
7600 geforce
200 gig maxtor 7200rpm serial ata/150 hard drive
and a basic cd rom
raid max 450 ps....and i tried brand new out of box 430ps with nothing hooked up but 1 stick of ram and processor..
tried it with out ram lol get same error 2 , 8.4 ,8.c


Windows XP Prof

[BUFF]

did you try with just the I DIMM installed (& is that th eoriginal Plat or Rev. 2)?
Raidmax aren't great PSUs - I don't know what the 430W was.

[deathdeeler]

well got the system fired up with 1 ram again set voltage to 200
got Hyperthread Warning from my guru its way overheating....
going to send board back ASAP

[BUFF]

doesn't have Hyperthreading ...
what temps weere you seeing?