IB9 boot problem

[scotty89]

Hi..
i jz brought my IB9 few weeks ago..
After i install all my OS n programs...
I jz reliaze that every time i boot up my desktop..
It will spin the fan a second 1st..
After that it wil just power up normally..
It is any problem with my BIOS firmware??
It is i have to upgrade my BIOS firmware??
I did't do any overclocking and did't upgrade any of my BIOS firmware..
Can i noe wat is the problem??
can i solve it??

Thx...

Sorry for my english..

[ABIT Sean]

Do you know what version bios you are using?

[DratUK]

Similar issue with a system I have just built for a friend.
Power on fans spin up then it powers off. Immediately reboots to desktop.
This also occurs on any bios changes made.
Bios updated to 1.2

Wasnt this an issue with the IP35 E?

[BUFF]

the double boot is normal for the IB9 (unless BIOS13 had it as an undocumented fix or Sean has a beta).

[ABIT Sean]

the double boot is normal for the IB9 (unless BIOS13 had it as an undocumented fix or Sean has a beta).

Yep Buff is right its perfectly normal. The IP35 should be fixed now but apparently there is nothing we can do about the double boot on the IB9.

[DratUK]

Thanks guys. Isnt a biggie but took some explaining to my friend

[scotty89]

O...So Sad to hear dat..
i scare the double boot will effect others hardware....
hope there will be a new bios firmware to fix this double boot problem...

thx for u all helps..

[ABIT Sean]

O...So Sad to hear dat..
i scare the double boot will effect others hardware....
hope there will be a new bios firmware to fix this double boot problem...

thx for u all helps..

It shouldn't cause any hardware issues. Lots of people have been running since it was released. Very low failure rate.

[[GSV]Trig]

I've got this on an IB9 too, bit of a PITA tbh, especially when your plugged into a monitor with dual input as it'll switch back to the other PC when it reboots, damned annoying..
COuld you wangle a BIOS so that it doesnt kill the gfx, at least that way it wouldnt switch monitors into standby or switch to the other PC if you have a dual input monitor?