i38 quad gt raid problem

[eggplant]

Hi all,

New parts arrived, i38 quad gt, 9400 quad cpu. Confoguration as follows:

Sata1 1x 500gb non raid to be system drive
sata2 & 3, 2 x 1tb raid 0
sata 4, 1 x dvdrw

Heres what happens, if I set sata mode to raid, I can enter the raid bios no problem and create the disk configuration above, I start installing xp pro, press F6 and install the jraid drivers which detects fine, however shortly after I get a bsod. If however I change sata mode to non raid it installs fine. If I enable raid after it is installed then it blue screens on boot. This indicates of couse that the raid/sata drivers/f6 disk are incorrect. The ones I used were off the cd supplied with the board, version:

[Version]
Signature="$CHICAGO$"
Provider=%JMICRON%
ClassGUID={4D36E97B-E325-11CE-BFC1-08002BE10318}
Class=SCSIAdapter
DriverVer=05/24/2007, 1.17.19.02
CatalogFile=jraid.cat

Any help greatly appreciated.

Thanks


BIOS latest bios downloaded from abit site m704d14

[BUFF]

Heres what happens, if I set sata mode to raid, I can enter the raid bios no problem and create the disk configuration above, I start installing xp pro, press F6 and install the jraid drivers which detects fine, however shortly after I get a bsod.

iirc jraid is for the JMicron which controlls the 2 external SATA ports on the backplate & not the internal ports which are on the Intel ICH9R.

[eggplant]

That would of course explain it ! I did RTFM but it was about as much use as nothing, no info at all. Im out at the moment but will recheck the cd but I dont recall seeing any other "f6 drivers" It is something for me to go on now though, thanks very much, I'll post back once I've had a look.

[eggplant]

Fixed, had to grab the intel drivers from abits site as they wernt on the cd. Have other issues now thought which I'll post on new threads.
Thanks again