Please help going nuts PC wont boot IP35 Pro

[jamieuk23]

PC has been working great!, went to power on today and it powers up for like 1 second and then keeps on making a loud bleeping noise and gives a code 9.0..

Have played round with the Ram and tried a diffrent GC and it still does the same thing.

Its a sudden problem that has happend on its own, and I havemt got a clue what the problem might be!, I have all so clearned the CMOS with no luck.

Any ideas on what I can do ?

Abit IP35 PRO
4870x2
Q6600 overclocked
2GB ram
850w PSU

[0iD]

Basic Beep Codes for ABIT AWARD BIOS Motherboards No beep at all - this means your motherboard is dead, either due to a defective or underpowered power supply, poorly seated CPU or RAM, or a dead-on-arrival board

One beep - board is working fine

One long beep then machine shuts down - faulty, improperly installed or missing CPU

1 short(Beep) System booting is normally

2 short(Beep) CMOS setting error

1 long - 1 short(Beep) DRAM ERROR

1 long - 2 short(Beep) Display card or monitor connected error

1 long - 3 short(Beep) Keyboard Error

1 long - 9 short(Beep) ROM Error

Long(Beep) continuous DRAM isn't inserted correctly

Short(Beep) continuous POWER supply has a problem

A two-tone siren, generally caused by overheating or out of specification voltages

Four beeps then machine shuts down. This is because this version of the BIOS will shut down your machine if no fan tachometer signal is detected on the fan header. Make sure you attach a fan to the FAN1 or FAN4 header or clear CMOS to reset to default (no checking).

Have you tried re-seating the CPU cooler?

[jamieuk23]

Have you tried re-seating the CPU cooler?

THANKS MATE! not that thou as its water cooled and on nice and tight.

[jamieuk23]

Do abit still do RMA ?

[BUFF]

yes, if within warranty - done from the Netherlands if in Europe.

Tried a different PSU?