KN9 SLI wont start, dead board?

[catfish]

Powered up the system for the fist time 5VSB and SLI pwr1 both on, no VCC light.
When I turn the PC on it starts then cuts out after half a second not even an error beep, the 5VSB light stays on but the SLIpwr1 light goes out.
There was no jumper on the CCMOS pins when I got the board and also the 4th pin on the CPUFAN socket was touching some sort of coil on the board.
If it were any other device I would have had an error beep I presume.
Is the board dead or could the PSU be no good?

Abit KN9 SLI
Athlon64 3500 ADA3500IAA4CN
1G espeed 533 DDR2
Nvidia 7100GS
Jeantech Arctic 600W PSU
250G SATA Western digital.

Thanks.

[catfish]

Does the CPU cooler have to be a 4 pin type cooler?
I’m also suspicious of the Jeantech Arctic 600W PSU.

Thanks.