i built my own camp and on the first boot it runs for 5 sec then stops, what do i do?
i built my own camp and on the first boot it runs for 5 sec then stops, what do i do?
you start by helping us to help you.
It helps others to help you if they know exactly what you are dealing with so please supply a full system specification incl. make & models.
If you put it in your sig. or "my system" then you only have to do it once.
have you set the memory voltages/timings correctly?
are you getting any beep codes?
but we really do need a spec list to do anything....
antec 900
abit ip35 pro motherboard
intel core 2 duo e8400
2g gskill ddr2 memory
corsair 750w
geforce 8800gt
seagte 500gb harddrive
what does the POST Code LED say? or nothing?
do fans spin up?
can you get into the BIOS screen?
hmmm, i wonder if it's that case of IP35's not liking some 12v rails again? see HERE
i cant get into bios, the fans run for 5 sec and the post code: 8.7
i have a tx series psu tho...
have you checked the 24pin and the 4/8pin connectors?
it may have been a problem that was solved in a later BIOS revision... so i would RMA the board and let them flash the BIOS for you.
but before you do that, try booting with just the bare minium in the system, (i.e. 1 stick of RAM CPU MOBO) and see if it will POST them...
but it is quite a widespread problem... so i would RMA it and get them to send you a new one (or yours but re-flashed) ...
theres a plethora of posts on various forums about it unfortunatly
Last edited by TAKTAK; 15-08-2008 at 01:50 AM.
assuming that the ATX12V1 is connected (most common cause of 8.7. is it not being) I suspect that it doesn't have a 45nm compatable BIOS so will need flashing using a 65nm CPU or a BIOS chip swap.
so in english all this would mean i need to get a new motherboard?
wat are the other options, and what is RMA?
Return Merchandise Authorization is where you return the board to the supplier and arrange for a repair or replacement or credit to your account.
and there aren't many other options... as it is a known problem with those boards...
There are currently 1 users browsing this thread. (0 members and 1 guests)