Runnning warm on water?

[StarkMjolk]

|SilentDeath|: Didn't know that was required... thanks They are tucked in warm as the vapos design with the PSU

[madocks]

Back to the subject.

I have made another waterblock today in work, and am feeling pretty proud of myself, piccy here............ http://www.guntha.btinternet.co.uk/waterblock.jpg only taken on my camera phone so exscuse quality.

I have ordered a new 120mm fan for my rad,

Also got a DD reservoir comming, some arctic silver, and a 1200L/Hr Eheim 1250 pump.

Any other sugestions?

[Shogun]

Cant see picture?

[madocks]

Cant see picture?

try again

[SilentDeath]

Looks good

[madocks]

haha!!!!! after a few hours of lapping the base etc, instaled the whole system now,

Getting temps (STOCK CLOCK) of 28 idle, and 31 under load

New pump comming tomorrow, so will clock it tomoorw night

[Shogun]

Block looks nice, can i have one? Would contribute of course

[GAteKeeper]

Lapping's fun isnt it.

Going to have a go at another block next weekend. Just need some 5mm copper/lucite sheet to use a top.

GateKeeper

[turkster]

Cool temps! Now you need to overclock

Your block looks very nice. Did you mill the polycarbonate as well?

[madocks]

yes, all milled , easier than filing way

cant wait to overclock this baby

[madocks]

Block looks nice, can i have one? Would contribute of course

Nah mate, with all the designing, milling filing, took me about 10 hours, can give you the design tho?

[madocks]

Lapping's fun isnt it.

Going to have a go at another block next weekend. Just need some 5mm copper/lucite sheet to use a top.

GateKeeper

My tops made out of perspex, that do ya? got loads here, will post you a square if you cover p+p

[Shogun]

Nah mate, with all the designing, milling filing, took me about 10 hours, can give you the design tho?

Its just the milling that i would have the problem with

[madocks]

Its just the milling that i would have the problem with

Ive got to mill my north bridge, once complete a very good mate of mine, ERU wants a north bridge and cpu block. If i Have time while im doing them I possibly can whack you a pair off.

However, thats a maybe, not a deffo.

[Shogun]

Ive got to mill my north bridge, once complete a very good mate of mine, ERU wants a north bridge and cpu block. If i Have time while im doing them I possibly can whack you a pair off.

However, thats a maybe, no a deffo.

Thanks alot mate

[GAteKeeper]

I have some 6mm perspex that would do the job - I am not continced of its tensile strength for use as a hold down plate as well.
Cheers for the offer though.

GAteKeeper