Building water cooling kit, fill in my blanks

[fat jez]

If it helps the OP, here's what I'm going for from Over-clock.

252 3/8" BSP 1/2" Barb - Nickel 1 GBP1.95 GBP1.95

274 1/2" BSP 1/2" Barb - Nickel 1 GBP2.60 GBP2.60

461 1/4" BSP 1/2" Barb - Nickel 2 GBP1.95 GBP3.90

71 Build a Kit 1 GBP121.07 GBP121.07
Fittings - Choose Kit 1
Fittings Size: 1/2" Fittings
726 CPU Block - Choose CPU Block 1
(inc pair of hoseclips & Y
Splitter if RBX or PolarFlo):
Alphacool Nexxos XP
428 Reservoir - Choose Reservoir 1
(inc pair of hoseclips):
DangerDen Bay Res
562 Radiator - Choose Radiator 1
(inc pair of hoseclips):
ThermoChill PA120.2
360 Tubing - Choose Tubing: 10
DangerDen Clearflex Tubing
1/2"
771 Additive - Choose Additive: 1
Zerex
64 Add UV Dye - Choose UV Dye 1
Color: Deep Blue
270 Compound - Choose Compound: 1
Arctic Ceramique
165 Selection of Double Fans - 2
Add 2x Fans & Guards: 2x
Nexus B/W 120mm

I'm also using the Eheim 1250 pump and ditching my existing setup. Swiftech Storm G4 was not available, or I would have gone for that. Apparently the Alphacool Nexxos XP is comparable to the G4 and has the advantage of mounting on the standard AMD heatsink mounting point.

Since the Antec Sonata II case I am using will be a tight fit, I'll install the reservoir in my spare drive bay, the CPU block on the cpu (duh) and route the tubing out the back through the grill by the PCI slots (I'll cut enough of that away) to the pump and double radiator (mounted using the Swiftech rad box) to the outside of my case and then back in again. I'll probably order it

res->pump->rad->cpu block->res

Cheers,
Stephen

[herulach]

DOnt know if the op is still watching this thread, but i have a mint, 1/2" barb 6" thermotube for sale, as i decided to go with a t-line for space reasons. Im looking for about 25 shipped.